2022-02-21
Cause and operation analysis of nanofiltration membrane fouling
Shenzhen Hongjie Water Technology Co., Ltd. produces pure water equipment, ultra pure water equipment and reverse osmosis pure water engineering installation and commissioning
Pollution analysis of nanofiltration membrane in operation
Microbial contamination
Microorganisms include bacteria, algae...
2022-02-20
Ten minutes to get the difference and use of cationic, anionic and non-ionic PAM!
Polyacrylamide (PAM) is a linear water-soluble polymer. It is the most commonly used water treatment agent in our sewage treatment. There is no one! In our practical application, PAM is divided into three types: cationic, anionic and non-ionic. How to choose these three types of PAM should start fro...
2022-02-20
Introduction of Runxin valve in water purification treatment
Runxin control valve is the first multi-functional control valve for fully automatic water treatment system with independent intellectual property rights in China. Relying on the principle of face seal, multiple valves are closely integrated on one valve body in a plane circumferential arrangement. ...
2022-02-18
The largest single water plant built at one time in Asia has been started!
Major projects in Dongguan started in the first quarter of 2022
It is a practical action to implement the objectives of economic development
It is a powerful guarantee for the steady growth of fixed asset investment in the first quarter
It is also an important measure to accelerate high-quality d...
2022-02-17
Do you have any operation specifications for the storage, re wetting and cleaning of membrane components polluted by organic matter?
In order to prevent the growth of organisms on the membrane surface during storage and the degradation of performance in subsequent operations, the membrane elements must be stored in a special solution.
New module:
(1) The membrane components have been tested with water before leaving the factory...
2022-02-16
Introduction to common accessories of Engineering pure water equipment
1、 Water inlet solenoid valve
The pressure range of inlet solenoid valve is 0 --- 10kg / cm2. Its main function is to automatically cut off the path between raw water and membrane when the equipment is shut down, so as to stop water flow.
2、 Raw water pressure gauge
The pressure range is about 3k...
2022-02-15
10 protection measures for ultra pure water equipment that must be collected
The protection measures of ultra pure water equipment vary slightly according to different parts. Different configurations have corresponding protection measures. Today we will learn about these protection measures that are very necessary to collect.
1. After using the ultra pure water equipment fo...
2022-02-14
Industrial application and market demand of secondary reverse osmosis + EDI water treatment and EDI deionized water equipment for water treatment
How to treat water?
This paper introduces a professional knowledge of sewage treatment - industrial application and market demand of secondary reverse osmosis + EDI water treatment and EDI deionized water equipment.
1、 Multi media filtration
The main task of this stage is to roughly filter the ta...
2022-01-20
Operation fault analysis of reverse osmosis system
preface
Reverse osmosis, also known as reverse osmosis, is a membrane separation operation driven by pressure difference to separate solvent from solution. Because it is opposite to the direction of natural infiltration, it is called reverse osmosis.
Faults caused by poor inlet water quality
In t...
2022-01-19
Discussion on resource recovery and utilization of reverse osmosis concentrated water
Discussion on resource recovery and utilization of reverse osmosis concentrated water
1. Basic information
The wastewater is concentrated brine discharged from the primary reverse osmosis desalination unit. Concentrated water will be produced during the preparation of pure water by reverse osmosis...
2022-01-18
How to debug the water treatment equipment? What steps?
The reverse osmosis water treatment equipment is divided into two parts, one is the pretreatment commissioning, and the other is the commissioning of the reverse osmosis host. The pretreatment is mainly the positive and negative washing of quartz sand and activated carbon to wash away the fine sand,...
2022-01-17
What is heavy pollution of reverse osmosis membrane
As a deep filtration means, the surface of reverse osmosis membrane element will inevitably remain colloids, microorganisms, impurity particles and insoluble salts on its surface. Therefore, once put into use, the reverse osmosis devices used in many fields will eventually need to be cleaned, but th...